Yamaha motorcycle gear indicator plug and play
How to install one Yamaha plug and play gear indicator
Find the red color 4 poles male diagnostic connector, it is usually near the ECU box. Maybe it is one removable cap and partially covered by black tape.
Connect the red cable to positive, and the green cable to RPM signal. They are important cables for making your bike work with this gear display.
After the installation, you need to set it up as below.
1.Set your motorcycle rear wheel on the stand frame, turn on the key, the gear indicator is flashing with the letter L. It means it is learning now.
2.Start your engine, the letter L will flash to number 1, now you need to change gear to 1.
3.In the same way, you set gear 2,3,4,5,6, please remember you need to control the tachometer with your right handlebar throttle, the gear position should compatible with your normal RPM.
4.Re-start your engine now, you can see gear number 0,1,2,3,4,5,6
Reset Gear number:
If you set by mistake and some gears did not set in success, you can delete setting. Turn on the key, when the gear number show 3 or 4 or 5, turn off the key soon. Repeat this action 6 times, you will see gears 6,5,4,3,2,1,L. Now the deleting process is finished. You can start set gears again.FJR1300(abs) 2003-2005
FZ8 non-abs 2010-2015
how long does it take?
12-15 business days, thanks
the indicator works, but the instruction is not clear enough.
thanks for fast shippment, i install it in success.
it is very good product with this value.